24/7 Customer Service (800) 927-7671

Additive Orthopaedics Develops 3D Printed Implant to Successfully Treat Hammertoes

by • July 11, 2016 • No Comments

3dp_AdditiveOrthopaedics_jointsA hammertoe is a deformity of the foot that typically presents in the 2nd, third or fourth toe as an overly bent toe that looks much like in shape to a hammer. It is caused by the joints becoming deformed by being bent for quite long periods of time, that causes the muscles to shorten. It is usually caused by wearing shoes that are too tiny or too narrow, or by wearing incredibly high heels that force the foot into a quite unnatural shape, yet hammertoe can in addition be caused by conditions as varied as diabetes, osteoarthritis, rheumatoid arthritis or actually a stroke. It can be an incredibly painful condition that can inhibit a patient’s skill to walk, and lead to other painful foot issues.

For quite mild cases of hammertoe, doctors usually send the patient to physical therapy and suggest replacing any tight shoes with new shoes that have quite soft insoles and are roomy adequate for the toes to be able-bodied to fully extend. Any prescribed physical therapy usually consists of a series of foot and joint exercises that can assist reshape the toe and practuallyt the condition of worsening. Doctors and physical therapists have in addition created special braces that force the toe back into the correct shape, but these can be quite painful to wear depending on the severity of the deformity, and they don’t always work.

Additive Orthopaedics LogoMany cases of hammertoe require to be corrected with podiatric surgery that involves surgically reshaping the afflicted toes. In fact additional than 1 million folks in the United States end up having to have a surgical procedure to correct their hammertoe every year. As with any surgery on the foot, this can frequently cause a excellent deal of pain, take weeks of recuperation in order to be fully mobile again and is no guarantee of it permanently solving the problem. But Additive Orthopaedics, a Little Silver, New Jersey-based early stage orthopedic extremity device maker and maker has revealed that they have that successfully treated a series of patients who were diagnosed with hammertoe via a new 3D printed hammertoe implant.

“Our implant has properties and showcases just possible through the additive producing system. We are confident that the market can respond well to this, our patient specific products in createment, and our other devices may already being reviewed by the FDA,” said the President and Founder of Additive Orthopaedics, Greg Kowalczyk.

3dp_AdditiveOrthopaedics_hammertoe_xrayAdditive Orthopaedics created their 3D printed corrective implant to be faster to make, custom created for the patient’s foot and to improve the chances of the condition being that successfully corrected. After the successful testing of the implant, the FDA cleared the hammertoe implant, producing it on the market-bodied to doctors all over the country. The young startup has may already raised adequate seed money to close their initially round and create the hammertoe implant. Among their investors is Asimov Ventures. After the successful tests, Additive Orthopaedics is readying themselves to open up a 2nd round of financing to assist them take their new product to market. They are in addition in the system of createing and gaining approval for new corrective implants for much like conditions like mallet toe or claw toe. Do you understand anyone who may benefit of one of these implants? Discuss over in the 3D Printed Hammertoe forum at 3DPB.com.